SacCyclone
Club Member
It's just a lot of hard work isn't it.....but when it's done you know what you have.
Make sure to take lots of pics along the way to show what you have been doing.
BTW, I used those same gloves when I was doing the Mustang floors....love those.
View attachment 53580
Looks good. The grommets just pry out, don't they?
I'd say a pry bar and bull nose pliers would make short work of thatCheers! And I'm sure they do - the rest did! I just couldn't get that specific pair to budge. Jammed a chisel under them and pryed with all my might, but they just seem to flex and stay put. I reckon the aforementioned jack method will pop them out though... Will try tomorrow.
I'd say a pry bar and bull nose pliers would make short work of that
Bright blue to see where you've applied and where you haven't I'd wager.Managed to get both floors done with the rust converter today - completing my aim of getting the floors all de-rusted, sanded and rust converted in one long weekend - her Maj would be proud!
The Bilt Hamber Hydrate 80 looks mad when you're painting it on - very bright blue - and then it dries to a kind of shiny looking black/bronze.
This shows the left side almost dry and the right side with a fresh coat on:
View attachment 53611
Might give both a second coat tomorrow night, and then it'll be a couple of weeks until I have time to epoxy prime the floors.
I think that is a air con related pipe that gets really cold when air con is on so has to be insulated.
You could prob just remove the insulation if it is disintegrated anyway. Depending on what you will use for air con in the future, factory system or after market system, this may be something you will remove anyway.
Definitely air con as I had one the same in mine (240z) - originally fitted by the selling dealer (air con was not a factory-fitted option when new).
Is the rest of the AC gubbins still in the engine bay?
Looks good. The closed cell liner foam is quite light, it's lighter than the hex matt. Good combo, I've got for the same. Just be sure where your sticking the closed cell foam, once it's stuck it's properly stuck and rips if you try to remove it.
Thanks! Great to hear the foam is lighter. So shouldn't be adding much weight at all then.
And yeah, I expected it will be tricky stuff like that. Is it easy enough to cut with scissors or do you need a stanley knife? What about the hex mat?
I was imagining I'd be making templates from card or thick paper for the hex mat, then cutting it out and sticking it.
Then with the foam was hoping to be able to skip the template stage and just line it up and cut on the fly?
And did you make holes for the rubber bungs in the floor or just go over them?
I bought a good quality pair of scissors for the foam, partly because I wanted a good pair of scissors when retrimming the rest of the interior but a cheap pair of scissors will do the job just fine on the hex matt and the foam. You could use a stanley knife though. With the hex matt I just measured out roughly and cut the hex matt then offered it up before removing the backing. As it's quite rigid there is no need to make templates, you can do all the markings and cutting before removing the backing. Just make sure you get a roller for the hex matt to ensure it meets all the contours and adheres properly.
I went over the holes in the floor initially and then used a blade to lightly cut the hex matt, careful not to damage the paint underneath and lifted the edge of the cut out to remove the holes ready for the grommets to go back in. Of course this is the way I've done it, it worked for me, but others may have other ways of doing it.