-
The Z Club relies on the support of it's paid members - join the club or renew your membership here.
-
-
MCBladeRun replied to the thread What did you do to your Z this week?.Took mine out for a spin to the spray painter mate of mine to discuss straightening/ panel beating and pulling the dents out 👍 Winter... -
MCBladeRun replied to the thread Gearbox Rebuild.When Mike (SacCyclone) picked up my car from the previous owner, he stated to Mike that he'd blown up the 3.6 diff and Mike was...
-
MCBladeRun reacted to Paul Atkinson's post in the thread What did you do to your Z this week? with
Like.
Started preservation of DaZ today. Engine out for rebuild. It has done 25 years of road and race spirited driving! Car off to bodyshop... -
I went to a local car meet on Sunday, It was nice when I left the house... then followed a bright orange Lamborghini Contach for a...
-
Prepared wheel hubs for welding 😊
-
I've painted my 240s rear light panel - Ford US shadow grey (thanks Richie :cool:) and Halfords matt lacquer. And I've finished...
-
Its 4 different shades of red and zinc primer!
-
MCBladeRun replied to the thread Hitachi carb parts UK?.Hi Carl Q1: needles, probably Burlen in the UK. Jets are a different story I'm afraid, I think Ztherapy in the USA are the only ones...
-
-
Since S30s don't have great options for jacking or lifting I wanted to remedy this and put points I could use as far to each corner as...
-
Bust the engine bay out of its masking cocoon for the first time in many months to start making painting preparations. The sealing coat...
-
Splash guards have also been made. I've started stripping parts of the RB to refresh them...
-
Using one of the 4 core radiators with shroud and twin electric fans. They really shouldn’t be sell this combo as the deeper 4 core...
-
MCBladeRun replied to the thread What radiator is everyone using?.I had mine refurbished through MPD - under £300 as they had to put copper / brass and not aluminium like modern stuff. But it is a...
-
MCBladeRun reacted to candy red's post in the thread Here we go again Derricks 260z restoration with Like.
Car now all done at Andy’s,what a great job he’s done of finishing off what I started :bow: Now ready for paint still not...
-
MCBladeRun replied to the thread MR.Z anyone remember these guys.He'll be able to 3D print a brand new Datsun with genuine patina before then 😂
-
-
Loading…
-
Loading…
