Strengthening brackets welded in a few welds to tidy up , then onto the strengthening plate over the steering column, can’t wait to finish this area under the scuttle panel so much work and now ready to move on
Well today had a few hours in the cold garage wasn’t sure what I was going to tackle next on the Z wanted to make the scoop/shield that goes on the panel under the scuttle panel,think it’s there to stop water going in the cold air duct to cockpit.
Made it in small sections as unable to bend and shape it in 1 piece.
A little bit more done tonight welded in the strengthening section over the steering column bracket wasn’t to bad but got a couple of welds not too happy with all penetrated well but just went slightly off centre easy to correct or I could just leave them as won’t ever be seen by me again but I just can’t leave them so will sort them in the week