Here we go again Derricks 260z restoration

:bow: Got your hands full there Derrick, but well worth getting all that rot out. Keep at it! :)
 
Glad to see you're still on it Derrick. Are you going to reuse that compression rod mount or do you have a replacement?
 
jonbills said:
Glad to see you're still on it Derrick. Are you going to reuse that compression rod mount or do you have a replacement?
Click to expand...

Yes John
going to reuse the compression mount thats what made it hard to remove as someone had welded plates to it so have had cut metal off as near to it as i could an then grind any excess metal that has been welded to it.:(
 
Hi Derrick that's not a small update!

It's good to see you back on here. Have you got some new chassis legs or are you fabricating them?
 
Rob Gaskin said:
Hi Derrick that's not a small update!

It's good to see you back on here. Have you got some new chassis legs or are you fabricating them?
Click to expand...

Good to be putting something on here again just been so busy with work and trying to get to customers that are chasing me for start dates :(

I've got new chassis legs to put on as I've got enough to do without fabricating them :)
 
Air-tube all cut off inner wing epoxy primed except for where new air tube is going to be welded on thats all been weld through zinc primed :) also cut out top part of inner wing and remade new section:(

AF2XZAH.jpg
 
  • Like
Reactions: Huw
You must log in or register to reply here.
Back
Top