Makesy
Club Member
Finished forming the fuel lines which was fairly straight forward. I also finished off the brackets to hold them in place.
lines ready to go,I tried to fit them....
What a b*****d of a job that was!
After a lot of swearing and recutting, I got them fitted, but I'm not over the moon with the outcome..
Growing fed up of the fuel system, I turned my attention to some bodywork...
Under the ash tray was some fairly unsightly surface rust.
A quick sand back and spray later and it should keep it at bay for now until I set about the full bodywork
Tonight I turned my attention back to the EFI. I wired everything up, save for the ACC input which I can't find on my car. Instead I resorted to a direct Positive connection with a toggle switch.
Coil back on...
I need to neaten everything up, as in my excitement it got.a bit untidy...
Fluids back in, I powered everything up and turned the key...
A bit of a chugg and.....
The car wouldn't start!
I think it may be a timing issue, as I'm sort of back to where I started when I first got the car.
I have a vacuum leak somewhere and the EFI is throwing up a TPS error code!
Needless to say, I am not best pleased!
lines ready to go,I tried to fit them....
What a b*****d of a job that was!
After a lot of swearing and recutting, I got them fitted, but I'm not over the moon with the outcome..
Growing fed up of the fuel system, I turned my attention to some bodywork...
Under the ash tray was some fairly unsightly surface rust.
A quick sand back and spray later and it should keep it at bay for now until I set about the full bodywork
Tonight I turned my attention back to the EFI. I wired everything up, save for the ACC input which I can't find on my car. Instead I resorted to a direct Positive connection with a toggle switch.
Coil back on...
I need to neaten everything up, as in my excitement it got.a bit untidy...
Fluids back in, I powered everything up and turned the key...
A bit of a chugg and.....
The car wouldn't start!
I think it may be a timing issue, as I'm sort of back to where I started when I first got the car.
I have a vacuum leak somewhere and the EFI is throwing up a TPS error code!
Needless to say, I am not best pleased!