Rushingphil

Great progress Derrick! I notice you have a spot welder on the floor - have you had any success with it vs plug welding with the Mig?

Rad support panel now all welded in place just need to clean the welds up , then put the grill brackets in place and give it all a coat...

Ginza showroom the Porker dealer had one of these

Fuse box mounted. Just need to put it back together and negotiate the wires in sensible directions. Last couple of pics are the igniter...

Really good point @Rob Gaskin. She's a Californian import, so in all honesty replacing the baked / perished bushings and a bit of a...

Whilst there is a lot of useful/interesting data and information on zhome.com, there is also a good measure of misleading and wilful...

So done a little more decided to put a strengthening piece in to both sides of rad support panel as it looks like it should have 1 will...

So I finally got the floors finished, minus dressing some welds. Here are some before and after pics. how did I do? I have fabrication...

Happy is an understatement bud. Honestly I am over the moon with it. He has smashed it out the park. I reckon he's saved me a few years...

The work on this looks superb.

Productive couple of hours on the car after work. Firstly the butyl sealant arrived in the post, so I was able to put the amber...

Little bit done tonight epoxy primed inside the box section for rad support and welded into place .🤓

I asked my youngest (who lives in Detroit) to buy it for me, to save on the postage and import taxes. Unfortunately, someone beat him to...

I asked him to do a few bits for me... he removed the RHD throttle linkage point, and he removed the passenger side wing stand things...

Then I got sent some images saying it needed a few final bits from him and it would be ready for me....