toopy
Club Member
Hopefully i will get to replace my wheel studs with longer ones some time in the near future.
Some people say knocking them out is fine, others say draw them out with a ball joint type extractor,
and some knock them back in, others draw them in with some spacers/washers and a spare wheel nut, oh, and never use a impact air gun.
In most cases they say do it one way but never the other, and there doesnt seem to be a definite consensus on either way!
I was going to knock mine out and back in, with the hub in each case on the bench.
So, how would you do it?
Some people say knocking them out is fine, others say draw them out with a ball joint type extractor,
and some knock them back in, others draw them in with some spacers/washers and a spare wheel nut, oh, and never use a impact air gun.
In most cases they say do it one way but never the other, and there doesnt seem to be a definite consensus on either way!
I was going to knock mine out and back in, with the hub in each case on the bench.
So, how would you do it?