Been trying to make the fans and lights work.
Should have looked into how the lights worked before I assumed and wired them in wrong.
Ditched my 3d printed relay block setup for simple separate relays for now.
Ended up struggling because the high beam switch was broken.
Stripped and cleaned and confirmed it was all working with some led’s stuffed in the end of the plugs - yellow dipped, blue high beam.
Once the wings go back on I can actually wire the real lights in.
Another little job ticked off. The threads on the Toyota gearbox are a lot larger than the Datsun one.
Solution was to hollow the gear knob out, 3d print a new insert and glue it in.
I added a little collar on the bottom to tie the gaiter to so that doesn’t slide down.