toopy
Club Member
Was going to start a new thread, but found this one which sounds similar to my problem.
Im doing a S13 swap and have removed the bell housing, the three rods that the forks slide up and down on, appear to have moved!
The lower one which i believe is reverse and fifth was sticking out further than the other two when the bell housing was removed,
so i pushed it back a bit, minimal force, but it now seems to have gone too far, compared to the other two!!
With the gear stick temporarily held in place, i can only select first and second, it wont move past neutral to the right, to select 3, 4, 5 or reverse, all gears were easily selectable before dismantling.
I have read through the posts in this thread, but i have no experience with gearboxes and cant quite get my head round what is or isnt happening
Im doing a S13 swap and have removed the bell housing, the three rods that the forks slide up and down on, appear to have moved!
The lower one which i believe is reverse and fifth was sticking out further than the other two when the bell housing was removed,
so i pushed it back a bit, minimal force, but it now seems to have gone too far, compared to the other two!!
With the gear stick temporarily held in place, i can only select first and second, it wont move past neutral to the right, to select 3, 4, 5 or reverse, all gears were easily selectable before dismantling.
I have read through the posts in this thread, but i have no experience with gearboxes and cant quite get my head round what is or isnt happening