Huw
Club Member
Has anyone had any experience of machining or turning a poly bush?
I want to replace the bushes on the rear subframe of my 280ZX with poly bushes to firm up its rear end a bit more.
These are no longer obtainable for the 280ZX, but the Z31 has a similar set up and there is a poly bush set available. Unfortunately the bushes are a bigger diameter and would need turning down some how, maybe on a lathe?
Anyone tried doing this with polyurethane?
The other option is to have a set made but that’s quite expensive
Huw
I want to replace the bushes on the rear subframe of my 280ZX with poly bushes to firm up its rear end a bit more.
These are no longer obtainable for the 280ZX, but the Z31 has a similar set up and there is a poly bush set available. Unfortunately the bushes are a bigger diameter and would need turning down some how, maybe on a lathe?
Anyone tried doing this with polyurethane?
The other option is to have a set made but that’s quite expensive
Huw