Farmer42

I have JR19s on mine. I had to go with a 7" as the 8" rubbed the arches. Would have liked 15" but couldn't get them at the time and...

Please dont tar all of us 2/2 owners with the same brush. Just think of all of the nice 2/2s you have seen and not that...

That is a very nice car. I hope it gets near the estimate.

I would suggest that you take the spark plugs out and turn the crank until the timing mark shows TDC on no. 1 cylinder then re install...

@Robotsan i think Paul means the oil & dizzy drive spindle. If you have only removed the dizzy and rotated its drive, you can only put...

You can if the drive shaft has been removed & reinstalled.

What dizzy do you have and are you running carbs or EFI? Timing should be around 10 degrees BTDC. Also check the timing mark as...

That's what I did with mine - rightly or wrongly. If it is still loose, it might be worth checking if the rubber o ring is seated...

Most good locksmiths or security place should have the keys or blanks. That's where I got mine done.

Thanks. I didn't get a tracking number with the e-mail saying it has been shipped. They have now been back in touch saying that they...

Did you have any problems with receiving parts from Z-Services? I ordered a new o-ring and locking ring at the end of April but it still...

Just found the notes I made on my phone for the Coupe fault. It was P0300 when checked was the O2 sensor fault. It wasn't that, it was...

Previous owner.

I had a similar annoying fault on my wife's Hyundai coupe a few years ago. Similar fault reading funny enough! I ended up replacing...

Those guys are regulars on Car SOS and other car programs. They do some good work apparently.