Russell
Club Member
The original brake and fuel line holders were pretty scabby, rusty, covered in old underseal and the rubber pretty worse for wear.
We have already put riv-nuts in the chassis rail rather than use the original self taping screw solution.
We bent some new holders and I designed and printed new rubber inserts so we shouldn’t have to worry about them again.
Pretty much the same as the factory ones but gives options if we need to change anything in the future, simply change and reprint them!
Pictures below in no particular order.
We have already put riv-nuts in the chassis rail rather than use the original self taping screw solution.
We bent some new holders and I designed and printed new rubber inserts so we shouldn’t have to worry about them again.
Pretty much the same as the factory ones but gives options if we need to change anything in the future, simply change and reprint them!
Pictures below in no particular order.