Paul_S

Hi all, I'm in a quandary. I want to buy a new cordless drill and impact driver set and would like some advice. I'm a keen DIYer with...

Here's a few projects Iv been working on Made on an an industrial SLS printer out of PA12 Nylon and a prototype for bolt in S30...

Joined the forum for a thread I came across, figure Ill post here too. From the US and current builds are a 70 L28et car and a...

Hello Z Club. New forum member I haven't looked at these cars for years. I still have a VGC 240z thats been sitting in my mother's...

Installed the 3D printed wing mirror as per below

A little pessimistic: I sold mine within Europe for €900 and another to the US for €1000. That sold in Europe is back UP for sale at...

Been a bit of a faff but I've put a new "retro" cheapie stereo in for tunes and podcasts AND Added rear 4" speakers The speaker mounts...

Bought a new 240z... Less than a tenner too!

Another 4 hours today. Absolutely fooking knackered, so it is beer o'clock. Managed to do almost everything on the right hand floor...

The 2nd dog leg is finished (well, might need a little filler in a couple of spots). while I was welding the top edge, I couldn't help...

Changed the gearbox oil in my S14 box from Redline MT90 to AMSOIL 75W-90 API GL-4. New favourite oil! The box is super smooth now and...

But hang on . On the dealer website - it was a z club magazine cover car ….! I’ve just put a cheeky bid of of £119501.50.

I had a visitor this afternoon, non other than Ian from the forum who kindly came round to help me cc the piston volume while...

Why not do the RHD conversion and all the rust repairs so the shell is solid, ready for paint and then leave it in primer? Knock a...

It looks like concrete floor paint ;)