Recent content by 260Zues

Hi Fairlineguy, I'm missing the larger one of the two, shown on the right in my picture. Any help appreciated! Many thanks, 260Zues

Hi all, I have a problem with recently purchased KYB struts. I've bought four new KYB ExcelG struts for my 260Z and had them shipped in from the states. The package appears to have been damaged on the way over and then taped up as I'm a hardware/fittings pack short... I can locate a nylon...

Hi all, I have a problem with recently purchased KYB struts. I've bought four new KYB ExcelG struts for my 260Z and had them shipped in from the states. The package appears to have been damaged on the way over and then taped up as I'm a hardware/fittings pack short...:eek: I can locate a...

I'm closer than that samuri-240... I'm actually just down the road in Chirk! Small world!! :-)

Hi, Thanks both, The prompt replies mean that if all goes to plan this weekend, I should have a rolling chassis come Tuesday... :-) Thanks again... 260Zues

Hi all, I have another question that someone out there can likely assist with please... I removed the stock springs from 1978 Datsun a number of years ago when I started my rebuild. I kept them paired up and labelled front/back ever since then but my son recently "helped me out" by...

Hi uk66fastback, I've found the below which appears to give me what I need (though there's a lot of cross referencing between this and google for what each part number actually is): http://www.carpartsmanual.com/datsun/Z-1969-1978 YellowZ, I've added "How to Restore your Datsun Z car by...

Hi all, I'm restoring a 1978 RHD UK 260Z and although the car might have been considered "complete" when I bought it, as all parts were present/fitted (and the engine was running!), the chassis and much of the bodywork was incomplete due to Mr. Rust. (15 years sat on a drive, exposed to the...

Hi all, Really sorry for the delayed reply... I hit a few minor issues with renewing my half shaft u joints, which confined me to my workshop for longer than expected... With regard to brakes...I've decided in the end to stick with the stock set up on the front and upgrade where I can (fluid...

Hi all, I'm after some advice with regard to changing the brakes on a Datsun 1978 260Z that I'm rebuilding and think you may be able to help. I've reached the point where my chassis/shell is back from the dead (sun roof is gone and I have floors!), I'm currently renewing the suspension with...

Unable to add 260Z Coupe? Hi Russ, I wanted to add my '78 260Z coupe but the form would only allow me to add the 2+2 varient? Kind Regards,

Sorry for talking "brake kits" on a "gearbox wanted" thread guys... I'm a bit of a newbie I'm afraid... Cheers,

Hi Dave, How much are the rear brake kits you mention please? Thanks