Is it me or does the J look like its riveted on?
The 'hatch' fit is amazing.Not 'this week' (it was a couple of weeks ago...) but having done most of the fitting-up on the LH side of the project 4/70 HLS30U, I dragged it out of the garage on the dolly, spun it around 180 degrees and put it back in again.
I only have enough space to work on one side at a time...
View attachment 54012View attachment 54011
The 'hatch' fit is amazing.
Is it me or does the J look like its riveted on?
Had a new exhaust fabricated at Redhill Classics, previous system had failed around several of the welds and I couldn't drive without stinking of exhaust fumes. New one looks much better and should "flow" better too.View attachment 54040View attachment 54041View attachment 54042View attachment 54043View attachment 54039
Thanks. Yeah it has factory underseal on it painted body colour. The black sections are where it scraped on some speed bumps so I cleaned it and applied Dinitrol underseal before had a chance to rust. Just need to repaint it red!Very nice! Also does your car have no underseal on it? Is it just coated with a wax or something?
Thanks. Yeah it has factory underseal on it painted body colour. The black sections are where it scraped on some speed bumps so I cleaned it and applied Dinitrol underseal before had a chance to rust. Just need to repaint it red!
It's got a lexus V8 in thereAh yeah I can see it when I zoom in!
Also, that exhaust.. can't help noticing a pipe coming from the other side of the gearbox too.. what's going on here then?!
It's got a lexus V8 in there
Im not convinced you haven’t got a mis match .Bought this 260/280z non Aircon heater box & controls a while ago but am having a hard time figuring out how to connect the two (don't have one for reference and the factory manual is vague to say the least!) I am pretty sure I'm missing some parts as the cables don't have a way of connecting the levers or the pull when the arms should be pushed etc. Would appreciate any images of similar boxes or guidance on what I'm missing/how to connect up. Also should the box and control panel join or do the mount in car separately?
The controls below are labeled and move as follows:
1) seems to be for a fresh air door? Only moves when moving from "off" to vent
2) seems to be for the lower flaps but can't see how to connect to lever
3) for the hot water valve but again not sure how it should connect
4) moves when selecting defrost but no cable and again not sure how it connects to the rod that moves the inner flap
Appreciate any help! Thanks!
View attachment 54049View attachment 54050View attachment 54051View attachment 54052View attachment 5405
You are doing Gods workWell been searching For RHD 240z was considering a 260z finally
But a forum member that none had this 72 Fairlady Z for sale
Well I left a deposit on her and buying her got plenty of spares get her back on the road
L20 engine in that's coming out for a l28