arcdef

Ha that sounds awesome! I forgot to add the Datsun club UK on facebook have a stand area booked so would be nice to get all the...

Yes I've got tickets and should be there in the truck with the 240z on the back hopefully

Is anyone planning to attend this? I'm planning to head down on the Sunday. https://retroridesweekender.com/

mine is difficult to remove as well, it almost feels like its going to snap but mine bent ok. Don;t blame me if you snap yours though!

I have no idea about time scales. Not going to rush through this one. Erm... I had him take it off, I'm sure it's around his unit...

Looking good! When are you aiming to have it on the road for? Also does Andy sell the throttle linkage points or do you have yours...

Mine were a tight fit and the pressure held them in place fine.

I used Timken which seemed to have the best reviews on quality however as Jon says unless they feel lose or "rough" there isnt a point...

I would recommend using Rockauto for the bearing, they are much cheaper in terms of price and shipping and will get here quickly. I have...

this is crossing the streams to me

I got a similar set to these but find that they 'ride' up the footwell and end up twisted. Any ideas on how to fix them beyond the...

Apparently it's the chemical they use to release it from the moulds? Either way I was scared after reading the reviews and then...

I'm running TR1s, great grip in wet and dry however the first few hundred miles felt like driving on glass!

Wheels will be 8J Rota RKR with 0 offset. Common set up isn't it, so hopefully will be fine. The infamous Petrolicious car has this...

My car has 225 50 16 fitted with 0 offset. Arches are rolled in the back though. You can probably go with a minor negative offset...