peter_s
Club Member
So here is my idea. The bottom mounting plate is complete.
This is the bottom side:
The top side has holes in it sort of opposite the hex bolt holes. That will make the glue form a "blob" in the hole that will lock the glue in place even if the adhesion against the plastic is poor. I only need good adhesion against the transmission tunnel.
Together:
Then I need to mount the fuel pump better, and put another filter before the pump. My earls metal mesh filter gets clogged.
So I will put another filter before the tank. And what should you do without vice grips? I can thankfully report no fuel leaked out after I disconnected some lines...
And maybe more importantly, a proper gear knob! A Vintage piece from Japan:
This is the bottom side:
The top side has holes in it sort of opposite the hex bolt holes. That will make the glue form a "blob" in the hole that will lock the glue in place even if the adhesion against the plastic is poor. I only need good adhesion against the transmission tunnel.
Together:
Then I need to mount the fuel pump better, and put another filter before the pump. My earls metal mesh filter gets clogged.
So I will put another filter before the tank. And what should you do without vice grips? I can thankfully report no fuel leaked out after I disconnected some lines...
And maybe more importantly, a proper gear knob! A Vintage piece from Japan: