AD240Z
Club Member
Afternoon
When refitting the hub to the spindle - should it take force to get the hub in place because of the inner bearing ?
When I pulled it apart - the hub and bearings slid off no problem. I’ve changed the races and bearings but when I’m refitting the hub - it won’t go on far enough.
When I pulled it back off - the bearing is jammed on the spindle ( assume it goes all the way on) at the top of the conical part .
As it came apart easily I don’t want to force it on - if something isn’t right ?
Any ideas gratefully received .
When refitting the hub to the spindle - should it take force to get the hub in place because of the inner bearing ?
When I pulled it apart - the hub and bearings slid off no problem. I’ve changed the races and bearings but when I’m refitting the hub - it won’t go on far enough.
When I pulled it back off - the bearing is jammed on the spindle ( assume it goes all the way on) at the top of the conical part .
As it came apart easily I don’t want to force it on - if something isn’t right ?
Any ideas gratefully received .