Turn & Burn
Club Member
I’m currently fitting a rear disc conversion as shown in the attached image using 200sx callipers.
Everything fits the hub fine, but the shortened suspension on the BC coilovers (about 50mm drop) is moving the hub upwards and the disc caliper and handbrake cable support arm into contact with the bracket that holds the brake line hose fitting (top left in the photo). The photo attached is off the internet, my hub unit is sitting at least 50mm higher than this.
Has anyone else had similar issues with discs and lowered suspension? I can’t find anyone with similar issues on the net and no talk of chopping this bracket off.
Everything fits the hub fine, but the shortened suspension on the BC coilovers (about 50mm drop) is moving the hub upwards and the disc caliper and handbrake cable support arm into contact with the bracket that holds the brake line hose fitting (top left in the photo). The photo attached is off the internet, my hub unit is sitting at least 50mm higher than this.
Has anyone else had similar issues with discs and lowered suspension? I can’t find anyone with similar issues on the net and no talk of chopping this bracket off.