s2k_adz
Club Member
Hey guys,
I need a 8-10mm spacer on the rear of my car to space out the ET9 Watanabes. Obviously then theres only about 3 turns of each nut until its tight so I really need extended wheel studs. A 5mm spacer works but the inside of the wheel is then only around 2-3mm from the coilover.
My question is do 350Z ones fit? These seem readily available in the UK whereas all the 260Z ones are US based.
Also on a side note I've fitted 25mm bolt on spacers up front for the ET25 wheels. These aren't hubcentric as the bore on the wheels is very different to the car. I read the Z is lugcentric at least on the rear so are these going to cause any issue? The cars not on the road as yet
I need a 8-10mm spacer on the rear of my car to space out the ET9 Watanabes. Obviously then theres only about 3 turns of each nut until its tight so I really need extended wheel studs. A 5mm spacer works but the inside of the wheel is then only around 2-3mm from the coilover.
My question is do 350Z ones fit? These seem readily available in the UK whereas all the 260Z ones are US based.
Also on a side note I've fitted 25mm bolt on spacers up front for the ET25 wheels. These aren't hubcentric as the bore on the wheels is very different to the car. I read the Z is lugcentric at least on the rear so are these going to cause any issue? The cars not on the road as yet