S30_Nut
Club Member
Happy Friday!
I'm pretty sure I know the answer to this, but with limited experience I would like some confirmation. Unfortunately Google has not given me the answers on this occasion.
Can anyone tell me if the stator should be able to freely wiggle about still? I would have thought that after setting the air gap it would be fixed in place. I can't seem to be able to tighten anything that would keep its position fixed.
The distributor is a D6k81-04 with the E12-80 module.
This is from a FSM for reference:
It also seems that the rotor head is able to move on the shaft, not freely as such; but its not like there is only one installation position, the variance is pretty wide, ~10-15 degrees perhaps. This also does not seem correct to me.
Appreciate any help and advice you can offer.
Cheers, James.
I'm pretty sure I know the answer to this, but with limited experience I would like some confirmation. Unfortunately Google has not given me the answers on this occasion.
Can anyone tell me if the stator should be able to freely wiggle about still? I would have thought that after setting the air gap it would be fixed in place. I can't seem to be able to tighten anything that would keep its position fixed.
The distributor is a D6k81-04 with the E12-80 module.
This is from a FSM for reference:
It also seems that the rotor head is able to move on the shaft, not freely as such; but its not like there is only one installation position, the variance is pretty wide, ~10-15 degrees perhaps. This also does not seem correct to me.
Appreciate any help and advice you can offer.
Cheers, James.