Clutch alignment

[Zed-the-red]

Its sods law. I have a universal clutch aligning tool and not one of them fits the spigot bush... I have seen a cheap aligning tool on the web specifically for the L24.
Any body have one I can borrow for a few minutes.. or if you have a tip. I was hoping to get the box back on soon. The old eyes are not what they were so trusting them to line anything up precisely is asking a bit much.

Ta.

 

[Rob Gaskin]

I use drill bits, insulation tape and pieces of plastic tubing - works a treat.

So if your bits are too small wrap insulation tape around them until they are the correct size.

 

[ben240z]

I use drill bits, insulation tape and pieces of plastic tubing - works a treat.

So if your bits are too small wrap insulation tape around them until they are the correct size.

a man after my own heart. Where there is a will there is a way.

 

[tel240z]

I use drill bits, insulation tape and pieces of plastic tubing - works a treat.

So if your bits are too small wrap insulation tape around them until they are the correct size.

A top tip there or this

 

[Zed-the-red]

I will give it a go today. cheers.

 

[SKiddell]

Similar here

3/8 extension bar with tape around it

 

[Graeme260z]

I used the 3/8 bar, works well also a small amount of grease around the gear box shaft helps.

 

[Mr.G]

May be of no help but in a weeks time I will be able to get hold of a clutch alignment tool I have and I am happy to post you for free. It is the clutch alignment tool which came with the stock clutch. Any good?