240Z badge positions | The Z Club of Great Britain
  1. The Z Club relies on the support of it's paid members - join the club or renew your membership here.

240Z badge positions

Discussion in 'S30 (240Z,260Z,280Z) Bodywork & Interior' started by Paul_S, Jul 6, 2019.

  1. Paul_S

    Paul_S
    Z Club Member

    Can someone do me a favour and measure the correct locations for the wing and bonnet badges please? I've got a new set to fit (when I get the car back...) but the locating holes have been blanked out by a previous owner and I decided not to reinstate them.

    I'm pretty sure the bonnet one needs to be in the middle left to right! I just don't know what the gap is from the tip of the bonnet.

    I've looked at photos of the wing ones so could make a good guess, but I'd appreciate some actual measurements.

    Thanks :)
     
  2. Paul_S

    Paul_S
    Z Club Member

    Anyone? :)
     
  3. jonbills

    jonbills
    ZClub Administrator
    Staff Member Moderator

    I'll measure mine tomorrow.
     
    Paul_S likes this.
  4. jonbills

    jonbills
    ZClub Administrator
    Staff Member Moderator

    110mm from the front edge
     
    Paul_S likes this.
  5. Paul_S

    Paul_S
    Z Club Member

    Very good thanks!

    If anyone can tell me about the wing badge that would be appreciated too :)
     
  6. jonbills

    jonbills
    ZClub Administrator
    Staff Member Moderator

    The centre of the badge is 110mm that is!
     
    Paul_S likes this.
  7. Mr Tenno

    Mr Tenno
    ZClub Administrator
    Staff Member Moderator

    Any use?

    20190714_190130.jpg

    From the edge of the panel:

    20190714_190100.jpg
     
    Paul_S likes this.
  8. Paul_S

    Paul_S
    Z Club Member

    Superb! Thank you! :)
     
    Mr Tenno likes this.

Share This Page