Search results

Hi all. I'm scratching my head somewhat over filling / bleeding my brakes (new T3 calipers front and rear). Initially I opened up each bleed nipple individually after filling the reservoirs obviously) and allowed fluid to reach the nipples in each corner. I then connected a hose/container to...

Hi All, I hope everyone has enjoyed the summer. I'm just in the process of installing my triple webers, and I'm just trying to figure out the fuel system, if somebody more clued up could please shed some light. I'm currently planning on sticking with the stock fuel pump, but obviously with the...

Hi Guys! Over the weekend I'm planning on removing the E88 head on my L24 for it to go away and get it's valve seats changed and cleaned up ready for a new camshaft / webers / exhaust etc. I've procrastinated a while over it with the panic of screwing it up. Do you have any hints or tips...

Hey guys, I hope you all had a good New Year. I've just shifted everything to my other garage to hopefully get stuck in to getting the car ready by summer (Terry's old car). I've got to send it to the bodyshop to get the front air dam and the zg flares installed. I was going to replace the...

Hi Guys. I finally managed to get it onto the lift this week so I could have a good look over a few bits. Whilst filling up with petrol the other week I found that there's a slight leak from the fuel sender gasket so I'm going to have to pop that out (any tips/things not to do?...obviously...

Hi All. I'm just figuring out the future steps of the things planned on the 240z, one of which being installing coilovers, and was just wondering if anyone a bit more clued up could clear some bits up please? I'm looking to get the coilovers complete without the need to cut and weld the...

Hi everyone. I was just wondering if anybody had an experience with RSpecCarbon (RetroSpec Carbon) in the US? I ordered some ZG flares from them in early September with a promise of delivery by October 7th. Since then, they are not responding to any emails requesting an update and obviously I...

Hello all. Whilst still waiting for some mechanical bits to arrive from the states, I've had a delivery of some parts from Skillard including an aluminium centre console. If I am to install this without modification, the choke lever will be an issue. My question is; if I remove the choke can...

Hello All! I hope everyone is enjoying the sunshine. I picked up my 240z last week, and one small issue it came with was the l/h window wasn't rolling down and the glass wasn't aligned (sitting slightly out of the frame). I resolved this fairly easily as the rear of the window wasn't within...

Hi All, Just to say a quick hello as I've just picked up my first 240z. My mum had a 280zx when I was younger so I've always had a soft spot for z cars. Chuffed to bits with it and looking forward to getting involved in some meets etc over the summer (fingers crossed). Thanks. Matthew