Search results

Does anyone know of anywhere in the UK that sells pattern front wings for a 240z? Thanks

Anyone know if FRP Automotive is still going? The website seems to have been pulled, I can't get through on the phone or via Facebook. I believe it was run by Throttleton on here so wondered if anyone had any knowledge of whether or not he was still operating? Thanks

I'm nearly there with my RHD conversion and went to fit the RHD wiper arm linkage last night. As you all probably know, the scuttle area already has the holes cut out for both LHD and RHD wipers. The problem which I somehow only just noticed is that on my LHD car, there are two supports...

I've been looking at front brake conversion solutions for my 240. I'm planning to use the T3 full rear end conversion which will allow me to use my rear 5-lug hubs and brakes from a Skyline. The problem is that T3 don't make a front end solution. A lot of the other kits I've seen for big...

I recently applied for my the first V5C for my imported 240z which has just come through today. On the US certificate of title that came with the car it listed the year of first registration as 1972, however the month and year of manufacturer as stamped on the identification plate on the car...

Hi all, I have a 71 US import which I'm getting closer and closer to getting MOT-worthy. Unfortunately I have just found that the rear right wheel cylinder is leaking. I have been looking everywhere for a replacement but the only ones I can find are 1. In the States and 2. absurdly...

Hi all, I’m hoping someone on here may be able to assist me with a wiring problem I’ve currently got. Long story short, I have set of indicator & light/washer switchgear which is not from the original car (year/model unknown), as well as a set which is from the original car (1971 US...

Hi, I have a US import. The indicators in the front wing are pretty worse for wear and I'm looking to replace them. I know of some 120Y units which l can get which look exactly the same (from a picture) but I can't be sure. Does anyone know if these are a suitable exchange? Many thanks

Hi I was hoping someone more knowledgeable than I might be able to help point me in the right direction on this forum. I'm looking for anyone who has documented their RHD conversion process. My apologies if it's somewhere obvious and I have just failed to find it but I have searched this...

Hi all, I've been lurking on this forum for a while now and absorbing all the detailed information that everyone is kind enough to share. I've been thinking about getting a 240z for some time but have been trying to decide on the best way to go about it. Like everyone else, I started off...