yellowz
Club Member
I have these brackets on the rear crossmember and I think they are for the anti roll bar. They seem to take a square roll bar bush.
My question is this, is there a specific metal tab that closes the bush in and clamps up? There is a hole in the down facing piece which accepts a tongue of a bracket and a captive nut above the circular hole.
if there is a bracket where can I get two, or will it be easy for someone to fabricate?
Thanks
My question is this, is there a specific metal tab that closes the bush in and clamps up? There is a hole in the down facing piece which accepts a tongue of a bracket and a captive nut above the circular hole.
if there is a bracket where can I get two, or will it be easy for someone to fabricate?
Thanks