Rear ARB Bracket | The Z Club of Great Britain
  1. The Z Club relies on the support of it's paid members - join the club or renew your membership here.

Rear ARB Bracket

Discussion in '240Z / 260Z / 280Z' started by yellowz, Jun 10, 2018.

  1. yellowz

    yellowz
    Z Club Member

    I have these brackets on the rear crossmember and I think they are for the anti roll bar. They seem to take a square roll bar bush.

    My question is this, is there a specific metal tab that closes the bush in and clamps up? There is a hole in the down facing piece which accepts a tongue of a bracket and a captive nut above the circular hole.

    if there is a bracket where can I get two, or will it be easy for someone to fabricate?

    Thanks
     

    Attached Files:

  2. jonbills

    jonbills
    ZClub Administrator
    Staff Member Moderator

    You are right, they’re the brackets for the rear ARB. You’re missing a mainly flat retainer with a bent tab that goes through the slot and a hole at the other end for the bolt to go through. Very easy to make I’m sure.
     
  3. yellowz

    yellowz
    Z Club Member

    You have not seen me with a hacksaw then! :rofl: Will work on it. Thanks
     
  4. jonbills

    jonbills
    ZClub Administrator
    Staff Member Moderator

    I could take a photo if you need it.
     
  5. moggy240

    moggy240 INSURANCE VALUATIONS OFFICER Staff Member Moderator

    I might have some, will have a look later
     
  6. yellowz

    yellowz
    Z Club Member

    Thanks for the offer. I can picture it already, if Moggy240 does not have any I'll try fabrication

    Yes please if available?
     
  7. moggy240

    moggy240 INSURANCE VALUATIONS OFFICER Staff Member Moderator

    I have had a look and I can't find any, the only ones I have came with a k-mac anti roll bar but they are not the right shape.
     
  8. yellowz

    yellowz
    Z Club Member

    Thanks for looking.

    J
     

Share This Page