Ian
Club Member
Got a few things to sort on this, main one is my pass side engine mount poly bushing has failed, not completely but enough to allow the engine to lean that way and now the downpipe is touching the chassis. I have a new one on the way, I think its the spacer I made that caused it to fail so I'll re-design a new one that bigger to spread the load more.
Once that's fitted and I can drive it again I've got to sort:
Indicators
Wheel Wobble
Way to add more adjustment to the steering arms.
Diff leaking some oil, think I need to reapply gasket maker, might also be spitting a bit of oil out the breather so I will extend the breather with a pipe.
Some slight oil leaks from the sump, think I'll remove and reapply gasket maker.
Head drain hose needs replaced as it got burned through by touching the exhaust, need to route it differently.
Rattle from rear pass side needs checked
Brakes need skimmed - have never been true since fitting, common issues with wilwood discs.
Got to get speedo working as I've failed to get it working taking a feed from the ECU.
That's going to keep me busy for a while.
Once that's fitted and I can drive it again I've got to sort:
Indicators
Wheel Wobble
Way to add more adjustment to the steering arms.
Diff leaking some oil, think I need to reapply gasket maker, might also be spitting a bit of oil out the breather so I will extend the breather with a pipe.
Some slight oil leaks from the sump, think I'll remove and reapply gasket maker.
Head drain hose needs replaced as it got burned through by touching the exhaust, need to route it differently.
Rattle from rear pass side needs checked
Brakes need skimmed - have never been true since fitting, common issues with wilwood discs.
Got to get speedo working as I've failed to get it working taking a feed from the ECU.
That's going to keep me busy for a while.