Mr.G
Club Member
Guys I need some tips in removing the old head gasket material from the head.
The block was easy, i used a gasket scrapper and had no problems, since the aluminium head is a lot more delicate I planned on using some gasket remover spray and a plastic scrapper - it doesn't work .
What I did use was a new blade from a stanley knife, even though I was extremely careful i still managed to lightly scratch the head in some places, so I stopped and here I am..
Any other ways of doing it? Should I worry about some light scratches?
Thanks in-advance for any advice.
The block was easy, i used a gasket scrapper and had no problems, since the aluminium head is a lot more delicate I planned on using some gasket remover spray and a plastic scrapper - it doesn't work .
What I did use was a new blade from a stanley knife, even though I was extremely careful i still managed to lightly scratch the head in some places, so I stopped and here I am..
Any other ways of doing it? Should I worry about some light scratches?
Thanks in-advance for any advice.