Rear Stainless Box For My 240z Help Needed

[PHIL HYETT]

Hi All .Need some help ,I have just ordered a new Stahl header from Mike for my 240Z as a Nismo are no longer available .And am going to totally re-design the exhaust system .2 1/2 ins from the new Y piece (thanks to Steve for his help ) to a new rear box . Now the rear box !! can anyone out there suggest a make or model that will fit ?? requirements are power stainless - size- fittment - and noise must !! be MSA sound legal .


Hope someone can help . Merry Christmas to you all .
Phil Hyett .

 

[twoforty]

I made a 2 1/2 inch for mine when I had the old engine in. I used 2 x 1mtr lengths, 2 x 90 deg bends and 1 45 deg bewteen the 2 90's. The back box was a (simons) oval, available from most motorsport shops. I got all mine from Merlin at CC. You could get all the parts from Demontweeks. Sounded great, not too loud. http://www.youtube.com/watch?v=6iyfGE3aMNM

 

[twoforty]

http://www.merlinmotorsport.co.uk/E...ER-OVAL-315MM-(115/165)-2.5/product_info.html

same as this one

 

[PHIL HYETT]

Thanks

Thanks two forty . Thats just the info i am looking for .cant wait to get my new header should, with the new exhaust make a lot of differance to the performance . then on to a carb up grade .

thanks again Phil

 

[evtech]

Got my back box off egay, it's from a supra, turned it over, chopped the mounts and fitted it with large cotton reel mounts 8mm, sails through noise, (but hey at the moment it don't make non )

Some shots in my gallery, as for the rest of my home brew it's all 2 1/2 no other boxes as the blower sorts the noise out quite well on its own.

Nige

 

[Tony 260Z]

I have a Kakimoto racing stainless box on the back of my 260. 2 1/2" inlet, 5" out. Fits perfectly. And its off...

a Z32

 

[PHIL HYETT]

Thanks

Thanks Tony any mods required ? and can you tell me were i might purchace one .

regards Phil

 

[Tony 260Z]

Phil,

I got lucky, there was a one-side rear-ended Z32 being broken. I had the box from the side that was OK. No mods to the box itself I think, but local exhaust fabricators put it on so not 100% sure. They probably just had to weld on a hanger.

Tony

 

[SeanDezart]

Phil,

how did you get on with your Stahl manifold ?