domtheboyo
Forum User
Hi,
Has anyone successfully replaced their Heater Core by themselves? I have followed the instructions from the Aussie site but ended up removing the dash to 'do the job properly!' However, I'm so far in I'm starting to panic just in case I can't put it all back together again!! My question is, do I remove the centre vents that contain the core or do I remove it via the footwell? If so, I would like to remove the entire matrix inc pipes as the new one from Nissan includes all of this. The instructions on the Aussie site say to remove the pipes from the core but on the new one these are sealed well and I don not want to break the seal and cause a new leak (and the replacement cost me £185). Any advise would be appreciated, or, if there is anyone here that lives near me in South Wales who could give me a helping hand??
Thanks,
Dom
Has anyone successfully replaced their Heater Core by themselves? I have followed the instructions from the Aussie site but ended up removing the dash to 'do the job properly!' However, I'm so far in I'm starting to panic just in case I can't put it all back together again!! My question is, do I remove the centre vents that contain the core or do I remove it via the footwell? If so, I would like to remove the entire matrix inc pipes as the new one from Nissan includes all of this. The instructions on the Aussie site say to remove the pipes from the core but on the new one these are sealed well and I don not want to break the seal and cause a new leak (and the replacement cost me £185). Any advise would be appreciated, or, if there is anyone here that lives near me in South Wales who could give me a helping hand??
Thanks,
Dom