Corsa EPS conversion - Anyone got one?

[Turn & Burn]

I’m about to start cutting up a spare column in an attempt to fit Corsa C EPS. It looks really tight under the dash and hoping it all together looks like a challenge!
Has anyone successfully done one and can you share any pics of the motor install. Which controller have you used, there seems to be any number to choose from but are they all doing the same thing.
Thanks

 

[Rob Gaskin]

https://zclub.net/community/index.php?threads/corsa-b-power-steering-converion.20715/

 

[Turn & Burn]

Thanks Rob, I’d read that one but still no pics. There are a couple on the Hybrid Z thread, but nothing really useful.
I’ve made a mock up column today and fitted the motor, in its best location it completely blanks off the discharge from the right hand demister. It may be possible to rotate it clockwise even further but this would required a cut to the column support bracket. I’m not sure if I’ll clash with part of the dash in this position either.

 

[Alphabettispaghetti]

As a side note, nice hoses, where did you get them from? Are you not putting the Jute stuff over the firewall also?

 

[Turn & Burn]

As a side note, nice hoses, where did you get them from? Are you not putting the Jute stuff over the firewall also?

Firewall has been sheeted with 15mm Dodo MLV, it’s hard to see as it’s also got a aluminium face. What a bugger to fit!
Which hoses?

 

[Alphabettispaghetti]

Firewall has been sheeted with 15mm Dodo MLV, it’s hard to see as it’s also got a aluminium face. What a bugger to fit!
Which hoses?

heater ones