Search results

Hi, the kit comes from the Netherlands as a complete replacement steering column. You remove your old column and install the new one and wire it up The motor sits up out of the way, you wouldn't know its there unless you look up under the dash.it apparently uses a connection that fits between...

Having been laid up for a couple of years dealing with NH Lymphoma and associated stays in hospital, at times my mind turned to my 260Z and what could be improved. I have had no problem driving the car with a track suspension setup with negative camber and larger tyres which tended to make the...

After reading up on the Mikuni HSR45 Flat slide carbies and seeing their application, primarily in the US, on various make and model cars, I decided to give them a try as a replacement for my triple Weber 45's. It wasn't that I was unhappy with the Webers, I just wanted to try something...

I know this car is a long way away from old Mother England, but just putting it out there as a matter of interest:- This car was the subject of a ground up restoration in 2002 and was built as a Tarmac Rally car. It has since featured in many magazine articles and has often been regarded as...

You mean like these? Mikuni HSR45 flat slides. Great carbs, smooth power, great throttle response and more economical than DCOE45 Webers.

https://youtu.be/hqdegnys4z4 A well put together video make sure you turn the sound up:)

A 240Z prepared by Stewart Wilkins Motorsport from NSW , Australia has won the Classic Section of the recently completed Peking to Paris Rally. After 36 days and 13,965kms the Pickering/Boddy 240Z came first about 40 minutes in front of a France/UK entered Volvo Amazon which was about 4 seconds...

Ultimate half shaft upgrade These are the best I can get with my Android, I hope they upload ok. As I understand it Stewart has new shafts made to the correct length and then treated and resplined, I believe he uses 280Z?? hub adapters which he has resplined to suit 260Z hubs (27 splines)

Send Stewart an email and he will respond. I have just bought a set to upgrade my original shafts, with the current exchange rate between Aus and the Old Dart they could be a reasonable proposition even taking into account the freight. Stewart supplies parts to many of the Z's running in the...

Great site Sean, especially liked the Cedric support wagons!! Geoff

Well done Hi Stefan, Loved the footage, great driving, any day you can cause a Porsche grief is a good day!! It's a pity Australia is so far away, would love to check out the event. Regards, Geoff Sydney, Oz

I am running triple 45's on a mild 2.8. It was my first time at the track, but it is nice and flowing circuit and great fun to drive in a Z especially when they are set up. Loved the Le Mans footage! Nurburgring was be fantastic>

Over the Easter weekend a Festival of Sports Cars event was held at Mt Panorama, Bathurst, west of Sydney. Although we had a bit of rain over the weekend we still managed to get in a few dry laps over the three days. As well as normal Group S and Marque Sports Car races, several of us Z owners...

Just an example of what some aussie Z owners are up to 'down under' http://www.zcarclub.com.au/forum/viewtopic.php?t=12

Datsfun, Do you know if these are going to be L20b's or L18's? Or some kinda of combo I understand the 180B's will be 1.8 to stay within the rules of the event. Geoff

Update from Stewart Wilkins Motorsport in Australia, he is very busy leading up to the EASR. He has three 180B shells he has to prepare for some Kenyan entrants (could be the 3 mentioned in the ealier post from Hatari) as well as a 260Z for J Savage and a new motor for the chap who purchased...

Hi Hatari, After reading your post of the 04 January, 07 regarding the car driven by Rob Collinge to win the 03 EASR, I felt I should clarify some information concerning the 240Z he drove. The car was in fact purchased by Collinge from Stewart Wilkins Motorsport in Sydney and shipped to...