Alphabettispaghetti
Club Member
84mm bore
Compression distance 1.379”
Dome height 0.035”
0.6cc positive dome
Intake valve pocket 0.120” deep x 12 degrees
Exhaust pocket 0.110” deep x 12 degrees.
I'm using an l24 block, l28 crank, l24 length rods. The pistons were designed as a 'cheat' gives me 2627cc. Big(ger) valve e31 head. 39cc. 10.5:1 cr, 294 deg cam
This gives me a rod/stroke ratio of about 1.68 against a 1.8ish as standard. The way I understand it this is slightly 'better'? Or have I understood wrong?
Compression distance 1.379”
Dome height 0.035”
0.6cc positive dome
Intake valve pocket 0.120” deep x 12 degrees
Exhaust pocket 0.110” deep x 12 degrees.
I'm using an l24 block, l28 crank, l24 length rods. The pistons were designed as a 'cheat' gives me 2627cc. Big(ger) valve e31 head. 39cc. 10.5:1 cr, 294 deg cam
This gives me a rod/stroke ratio of about 1.68 against a 1.8ish as standard. The way I understand it this is slightly 'better'? Or have I understood wrong?