Dear Z heads,
My 260's temp gauge was always showing less than a quarter sweep. So I shorted the engine bay connector and it swept all the way.
I just replaced the sender unit and it sits just under half way. The way I figure it is that it's sitting at 180F which is about 85C.
My question is, is that where it's supposed to be? I've read on some forums that it should be three quarters across which sounds hot to me. Any thoughts ?
Thanks in advance!
Ali
Sent from my iPhone using Tapatalk
My 260's temp gauge was always showing less than a quarter sweep. So I shorted the engine bay connector and it swept all the way.
I just replaced the sender unit and it sits just under half way. The way I figure it is that it's sitting at 180F which is about 85C.
My question is, is that where it's supposed to be? I've read on some forums that it should be three quarters across which sounds hot to me. Any thoughts ?
Thanks in advance!
Ali
Sent from my iPhone using Tapatalk