RawlinSTR
Club Member
Hi all,
Finally managed to source some side air vents for the dashboard in my 240Z, but I’m struggling to figure out what sort of hardware should be used to mount them to the dashboard.
There are three captive nuts on the dash frame which look very small diameter, whilst the diameter of the three holes on the dash vent housing (pictured) are quite large diameter.
Anyone currently have their dash out of the car that could enlighten me? Should I be using small Philips screws and large washers?
Any help appreciated, thanks
Simon
Finally managed to source some side air vents for the dashboard in my 240Z, but I’m struggling to figure out what sort of hardware should be used to mount them to the dashboard.
There are three captive nuts on the dash frame which look very small diameter, whilst the diameter of the three holes on the dash vent housing (pictured) are quite large diameter.
Anyone currently have their dash out of the car that could enlighten me? Should I be using small Philips screws and large washers?
Any help appreciated, thanks
Simon