Search results

Anyone in he UK rebuild 240z carbs, or is it more or less a matter of going to zTherapy (currently a 9 month waiting list!)

Have managed to loose the plug for my original 240z radaitor (the "wing nut" style nylon/plastic drain plug) Does anyone know what the dimensions are so i can get a replacement?

I've measured the lash pads and they are all within a few hundredths of a mill off the 3mm so they are fine.its just the two where I think the machine shop has sunk them a little too much into the ehqd that I'm going to put thinner pads on. Here is another picture of number 4 once I re did it...

Haha - have you had to do this job in the past jon? there is literally nothing i can feel on those - ill maybe clean one up and take another pic so you can see. Ive even tried again with my pinky finger and i can feel nothing there. I also "reblued" #6 in again and redid it and there is a...

RE the work done, I got a slight head skim, and then i got new valve seats and valves then bedded into them. Ive been reading up a fair bit this week, and from what i understand, its not entirely uncommon for people to shim (use different lash pad depths) on individual lobes. I have ordered a...

My machine shop did a valve job and they appear not to have adjusted the valve lenghts on all occasions, so in a couple of the exahust valves, im finding that i dont have enough adjustment range to get the correct gap (e.g. where i should be able to get 0.25mm cold gap for the exhaust valve on...