Search results

Datsun 240z, 1972, manual. Original 2.4l engine and gearbox. The metal work on this car is in exceptional condition. Was a very solid Californian import to start with. All welding has been professionally done. The only area which could be improved on if required is 2 small sections on the rear...

Thanks DPT Yes it will be helpful. Please send instructions. Thanks again

Hi Could someone please tell me what bushing this is. I need to purchase a new set for the lower wishbone and I am not sure what it's called specifically. Can some please let me know what to search for on ebay or provide a link of what to buy. Many thanks

Photos

Price reduced

Thanks for the help. I'll buy one of these.

I have replaced my factory original mechanical fuel pump twice now with an aftermarket one from ebay. On both occasions the pump works fine for a very short while. About 5 or so trips then it fails. I believe the the diaphragm in the pump gets weak as it must be an inferior product. I...

Datsun 240z, 1972, manual. Original 2.4L engine and gearbox. New house forces sale. The metal work on this car is in exceptional condition. Was a very solid Californian import to start with. All welding has been professionally done. The only area which could be improved on if required is 2...

Thanks. Yes, have checked all the correct bulbs are fitted. Checked the earths and made a new earth which helped with the brightness. Still can not find the problem with the brake light. We ran a wire directly from the switch to the wiring loom at the back and now the brake lights work but...

Hi. The car is from california

Hi I have been trying to fix the rear indicators with no success. Does anyone have any ideas? The left indicator works but I do not know if it is normal that it flashes red (top left light flashes) as well as the white light which is lower right. Both flash. When I turn on the right indicator...

Ok. Not to difficult from the sound of it. What did it cost in total? Trying to figure out weather its worth buying these or getting my originals fixed. There is a company that come out and repair them onsite for around £200 to £300 depending on what is needed.

How do you like it and how much did it cost in total? Was it easy to install?

Hi I have been looking through the threads on here and could not seem to find an answer unless I missed something. I have a 1972 240z. The seatbelt mechanisms do not work properly. One does not retract and the other does not pull out. The side that does not retract had a broken spring when I...

Just to let everyone know that my old 280z will be on salvage car hunters tomorrow on Quest at 9pm. I sold it to them about 1.5y ago. Hope it will be interesting

Sorry. Can't help with that bit. That's why I sent it to him. I tried for a while to figure it out but had enough.

Hi You need to fit your low pressure fuel pump in place of the high pressure fuel pump on the car for the EFI system. You then need an electrician to check the wiring as when you remove the EFI system and ECU your car may not start. I had to have some wiring work done on mine. Once that all...

Datsun 280z survivor car. Tax and MOT exempt. Unfortunately I am having to sell my lovely Datsun 280z. 1977 2.8L 5 speed car. Never driven in the winter on the salty roads. It is kept in my garage. This Datsun is not your typical 280z. It is completely original as far as the body goes. It...

It's not too badly worn. I just wanted to sort it if possible before I put it all back in the car. Once I did go from 5th to 4th on the dual carageway and it hit reverse. It was one time so not sure if it was that as the car is so old. There were some metal filings on the magnetic plug but I...

Hi Does anyone know where to buy or even if it is possible to buy gears for the 5 speed original 280z box. I have removed my gearbox in order to replace seals, clutch etc and noticed that there is wear to the reverse gear. I have been trying to buy a new reverse gear from USA but can't find...