No the head has literaly been taken of and the only things i have touched are the ports
But that is a good idea il try putting going throghe the towers thanks
Just looking to see if anyone has any ideas i have a n42 head that i have been running over the summer with no issues at all i have taken this head of and fully rebuilt the bottom end and have done a bit of light smoothing and porting of the head. I have just gone to put the new uprated cam in...
Hi all finaly started driving my z after a year and a half resto/mod and i have purchest the 123 ignition distributor as an upgrade along with webers. Im very very please with it its a ver nice bit of kit! What i was wondering is if any one on here has used one of these befor and managed to hook...
cheers
I will get some interior pics soon I have still got a few things to do inside like door cards and other small trim but nothing that's going to stop me driving it haha
got the 240 a new mot and the reg documents turned up today so its all go here are a few pics of how it turned out. so happy with how it came out way better than I expected
just hope it drives as good as it looks ha
still lots and lots of bits to get done on it and many more upgrades that I...
Hi all
I apologise if this has already been covered
I have just finished my 240 with was imported from the states and im trying to get it a registration and was wondering if anyone has recently done this?
I have tryed getting the info from the dvla web site with is terrible and confusing ...
So a little update on the z
I Now have a fully working and l28 motor in! The l24 that was in it was junk very very low compression and would not ever fire! Luckaly found an l28 out of a 280zx. Pulled the head off and had to do some repairs to it and new seals port matched wile it was off as...
Thanks im pretty pleased with the progress
Im going to run the original 4 speed and rear diff for now but will definatly look in to upgrading them in the future
Ye the floors were pretty much non exsistant on the passenger side not as bad on the drivers but luckally it hadnt spread to the inner sills so i was able to cut what was left of the old floors out and weld the new pans strait in with a bit of cutting and bending.
As for the coil overs i...
Hi guys
New to the z community i have wanted one for a long time and in October last year i managed to find a 73 240z that had been recently imported from Texas that was within my budget. The car had been sat in a barn for 20 something years and was in pretty bad shape it had pretty much no...