Throttleton
Well-Known Forum User
Seeing as this is a forum and as such a source of info
That is why I haven't rung you up (yet!) Steve.
I was hoping by the end of this thread other novices would not feel too out of their depth to have a go at rebuilding an L series engine.
If you and others with the knowledge can share your information on here it gives the forum a 'point' don't you think??
'Trade secrets' and other info you have gathered over time at your own time and expense is another matter........
Putting you on the spot now.....
Do you think the oscillating tool you mentioned used correctly will be as good,better or worse than an engineering shop would achieve??
The cnc set up is too extreme for what I hope to achieve and probably too costly though I am only guessing. My target is a well built engine and increase the power to weight ratio through obvious means.