Search results

So I got abit carried away cracking on with the car getting the frame rails in since the jig has been finished, but I've made a quick drawing of the jig hopefully this is helpful to someone. Please not this is for a 2+2 meaning the spacing of the mounting points are longer, these can be changed...

So a quick question to anyone that might be able to help. Im still head scratching to verify the horizontal spacing of the each jig section, Im finding the factory service manual PDFs to be hard to read in locating the bolt locations and the associated measurements. i'm hoping someone may have...

Thanks ben, sounds like a good shout. I've already for a bracing bar across the top but just not connected to the jig. Will be something I can get on with today

Thanks mike! Slow progress

So a quick update on the jig build, Most of the frame is made and in for test fitting, went fairly easily apart from verifying the horizontal positioning, still trying to figure that out... Its a slight tweak on a build from conVerTT over on the classic z club forum Also the chassis rails...

Thanks again Alan! I'll be on the search for one. Now time to get the steel ordered for the jig, in the mean time the chassis rails are ready to be fabbed up.

thanks alan thats a absolute god send, i had the info from the coupe models but couldn't seem to find any info on the 2+2, was this a file from a website? would be handy to see if there's any other 2+2 information out there i might meed:conf2:

Hi everyone, I've been lurking in the shadows for the last six months. But I've reached the point where the internets information for the 2+2 has been exhausted. I've currently taken up the task of replacing the chassis rails which are shot and so will be needing a jig and to that point brings...