Search results

Where can i get replacement seat covers for my 260z seats? I noticed a while back a company that does them ,but can't find it.

I have been breaking a 260z 2+2 and have a good few bits left and thought i would just mention i will be going to japfest 2 so any parts you may want just ask?

Im hoping to strip the rear wishbones down on the 260 im breaking?Is there any tips to removing the long shaft that goes through wishbone,I have removed each end nut's and removed cotter pins..I just want to get these stripped so i can sell them..

Trying to think of the film??Quite old.If i remember rightly car got smashed up reversing??Help me??

Trying to contact a man called Gerrard??Cant remember his username but he is based in Ireland..Cheers for any help..

Just bought a 260z 2+2 and had a look over it.Needs quite a bit of welding like the one im helping my brother in law with..Question is do i break it.The wings are really good and so are the doors,and theres aother good parts.My Brother in law wants some of the bits for his ,but what to do??Im in...

How do i post a car in the classified section???Doesnt seem to work?:confused:

Unfinished project!!!Cant seem to post in classifieds section?? 1978 DATSUN 260Z 2+2 MAUVE/PURPLE

Thinking of buying a 350z any advice??

edited

Just after some help really!!!On stripping the rear suspension the lower long bolt which has a nut either end got knackered.I can get a new one made in stainless steel ,will this be okay?as i asume the original bolt would have been high tensile or similar?Is there different grades of stainless...

Can someone tell me how to strip a drive shaft as im after changing the joint..?Or point me in the right direction..

Just thought id post some pics.I warn you it looks rough.. The floor which had large hole..

Are 260z engines ok to run on unleaded??Not that the cars ready yet infact its a long way of..

Been doing some more work on 260z.I have been fabricating part of the inner wing under battery mounting as it was very rotten.Both rear arches that looked ok have been stripped to metal to find filler so am going to cut out arches and replace.Im trying my best to get as much rot out as possilbe...

Just thought id join this site as im currently helping my Brother inlaw restore a 260z 2+2 which has been standing a while.Ive just been made redundant so have spent most of the time helping him..