Recent content by Balloo2u

Major issue and stall point was the roll cage. Once it was done badly the project stalled, dealt with 2 companies after that who where supposed to rectify the issues but both of them where not what you would call professional. Currently cage cut out awaiting new one. Replacement sills tagged...

Called an end to the saga as I was screwed over one too many times. Lots of bits going up on eBay today so bargains galore. http://www.ebay.co.uk/usr/rossqpd Currently valuing the 73' chassis which has space from front end but need a lot of work to complete.

Getting there https://www.facebook.com/RB30240z/photos/a.266265440197913.1073741834.208595702631554/390794237745032/?type=1&theater

Yup, May 2014...............slipped abit :D Looking to get in moving before 2016.

Check out page 2 of this thread :D

Hi Graham, Procoatings UK did it for me. It was a task and a half as the cheap fibreglass dash was in a right state when I handed it to them, will pop up the work they put into it in a bit. All in it was around £250 due to the prep work. I got the dash for around £70. They will be doing a...

Hopefully 4/6 week turnaround for the rollcage, welding and new roof. Then straight to the spray shop.

Still trying to find parts that don't need replacing :D

Having some slight issues at the moment but expecting finished product soon.

Keep an eye out on Skylineowners.com Skyline-owners-club.com and gtr.co.uk/forum Second for JM Imports if you want to bring something specific in and like above if you can afford it R32 GTR, as unmolested as possible is your best bet. Main thing is to try and get some seat time in each of...

A quick update, shell back home after a few saga's. Set about sorting out the shell again, garage had her for a year so surface rust built up. A few days of elbow grease and we are back to something salvagable....hopefully. Minion at work: Before and after: Getting there: Luckily when...

I have a set off at EPRacing being used for carbon molds.

The non carbon bits (front wide wings etc) will be carbon wrapped with alot of JPS style graphics over the car.

Oh and another little update. Dipped dash.

Thought I would pop a quick update on here. We are pretty much back to square one with the project. We have however booked the chassis into Andy Robinson Race Cars to have the rollcage redone and hopefully salvage some of the front end. A very very expensive lesson learned.