Wing to Inner wing foam pad | The Z Club of Great Britain
  1. The Z Club relies on the support of it's paid members - join the club or renew your membership here.

Wing to Inner wing foam pad

Discussion in 'Bodywork & Interior' started by yellowz, Jul 1, 2019.

  1. yellowz

    yellowz
    Z Club Member

    20190701_195853.jpg 20190701_195904.jpg I have just taken the wings off my car to clean everything up and find more rot I expect...........

    Have discovered that one wing has a foam strip running running down it (definitely home made) and the other does not. Are these standard with one missing or not standard and I've got one for a reason I have not worked out yet?


    Any info or jokes appreciated :)

    Thanks
     
  2. jonbills

    jonbills
    ZClub Administrator
    Staff Member Moderator

    There should be rubber strips between the inner and outer wings, and they clip on to the inner wing seam. I guess someone has Improvised on yours.
     
    Last edited: Jul 1, 2019
  3. Makesy

    Makesy
    Z Club Member

    Almost certain my car doesn't have these when it probably should! Another thing to check!
     
  4. IbanezDan51

    IbanezDan51
    Z Club Member

    I had foam on my original US car. Stuck on. It’s part of the nvh and stops dirt flicking up the inside of the wing.

    It’s original as far as I’m aware and I made some new ones up on the other car.

    The rubber strip fits along the top of the wing.
     
  5. chris frizzell

    chris frizzell
    Z Club Member

    may be just as good to use some silicon sealer bits of foam are a little dated if only to keep water out
     
  6. yellowz

    yellowz
    Z Club Member

    Thanks, mystery solved!
     
  7. IbanezDan51

    IbanezDan51
    Z Club Member

    Wouldn’t use silicon it’s not good for bodywork especially bare metal.

    Just buy some sticky back foam and make a new gasket/seal.
     
  8. Bernard N

    Bernard N
    Z Club Member

    Try Seals direct
     

Share This Page