What did you do to your Z this week?

Kieronpollock

Club Member
Note to self, to assist my OCD, when buying 3 boxes of sound deadening and OEM firewall sound deadening, make sure you buy all of them in the same colour 🥴
Fuel and brake lines in, prop shaft and gear box in, electric fuel pump in, engine builder moving on to putting in engine tomorrow.🥳
Still on for JDM in July? Place your bets guys!
 

Attachments

  • FB17CB20-FCD2-4528-81D4-C48DAC216572.jpeg
    FB17CB20-FCD2-4528-81D4-C48DAC216572.jpeg
    92.1 KB · Views: 26
  • 7D6FC820-AA8D-44F2-BD60-A24D4F374F73.jpeg
    7D6FC820-AA8D-44F2-BD60-A24D4F374F73.jpeg
    185.5 KB · Views: 25
  • 7B91B8B3-7921-4029-AAB0-7B2984C781A9.jpeg
    7B91B8B3-7921-4029-AAB0-7B2984C781A9.jpeg
    128.4 KB · Views: 26
  • 3940AF6F-11C5-4401-A930-25D1B5D14D59.jpeg
    3940AF6F-11C5-4401-A930-25D1B5D14D59.jpeg
    107.8 KB · Views: 27
  • CECD6ACF-9C20-4FC7-A63C-BED4D7B64936.jpeg
    CECD6ACF-9C20-4FC7-A63C-BED4D7B64936.jpeg
    133.7 KB · Views: 26
  • DD18AAFD-1B1C-4327-85C1-4DFDA29BC18D.jpeg
    DD18AAFD-1B1C-4327-85C1-4DFDA29BC18D.jpeg
    122.8 KB · Views: 26
  • BEC3C817-508D-4CAE-9A12-C6A0618F0576.jpeg
    BEC3C817-508D-4CAE-9A12-C6A0618F0576.jpeg
    107.2 KB · Views: 29

240L31

Club Member
Taking the top panel off was fairly obvious, although the spot weld locations weren't all obvious.
How to cut out the next layer needs a bit of thought - not sure where to make the cuts yet. Anyone? :conf2:
Just a tip: brush the panel in question with a rotary steel brush first, all the spot welds will shine up instantly (they get polished). Following I used a pen and marked all positions to drill.
 
Top