Discussion in 'S30 (240Z,260Z,280Z) General' started by jonbills, Oct 7, 2017.
Propshaft uprade is easy. Get one made using the landrover UJs. Never had one break since I went this route.
Does this look like the right thing? Hope so!
Looks spot on to me.
Can I ask how much it was? I will need a driveshaft made/adapted for my 1JZ's gearbox at some point and not sure the best place to take it
It was £150 for that whole new end, cleaned, balanced. Not sure it’s the cheapest but looks the part and was only 10 mins walk from work and turned it around in a day.
This was Northwest propshafts in Salford. I’ve also used bailey morris in cambs and would recommend them too.
You’re futher south aren’t you?
Good to get an idea of costs as I will need mine to be strong.
I’m all the way south, about 20 mins from the coast in West Sussex
Sent from my iPhone using Tapatalk
Russell - go with the same 1310 joint on the rear that Jon has used and keep the Toyota front end. I've never touched the Toyota joint.
Who did you use?
JW engineering in Bexley heath
Separate names with a comma.