Weber Carb Mounting | Page 2 | The Z Club of Great Britain
  1. The Z Club relies on the support of it's paid members - join the club or renew your membership here.

Weber Carb Mounting

Discussion in 'S30 (240Z,260Z,280Z) Engine' started by nickknox, Apr 26, 2020.

  1. jonbills

    ZClub Administrator
    Staff Member Moderator

    The float chambers will fill slightly slower with 150. I still think you'll be fine with 150s. if the 175s are in good enough condition, hold onto them and swap them back in if it goes lean at the end of the Mulsanne straight.
  2. Rob Gaskin

    Rob Gaskin Treasurer Staff Member Moderator

    :EXTRAlol:It aint a straight any more - in fact it never was to be picky'
  3. nickknox

    nickknox Well-Known Forum User

    Idle adjustment screws are very different

    Sent from my iPhone using Tapatalk
  4. jonbills

    ZClub Administrator
    Staff Member Moderator

    is the thread the same size? otherwise looks like it should work OK.
  5. Albrecht

    Albrecht Well-Known Forum User

    Did you buy the correct rebuild kits? You should have bought the one with the 'early' replacement mixture screws. Looks to me like you have the wrong rebuild kits with the 'late' type mixture screws.

    WEBCON 'WE436' should be the kit for your early 40DCOE-18s.
    jonbills likes this.

Share This Page