Today's Dyno results | The Z Club of Great Britain
  1. The Z Club relies on the support of it's paid members - join the club or renew your membership here.

Today's Dyno results

Discussion in 'General discussion' started by Fairlineguy, Nov 23, 2017.

  1. Fairlineguy

    Fairlineguy
    Z Club Member

    My plan was to run with the stock rb25 ecu but last week I bit the bullet and had installed a Link G4 ecu.
    Today Richard at Rising sun (bells autos) set up the ecu with a couple of maps which can be switched via a switch inside the car.
    The link ecu has a couple of other features which can be wired in One would provide traction control with addition of a couple of extra sensors
    But for the time being its also operating the cooling fans and will control the a/c compressor
    [​IMG][​IMG][​IMG][​IMG]


    Sent from my iPad using Tapatalk
     
  2. Fairlineguy

    Fairlineguy
    Z Club Member

  3. SeanDezart

    SeanDezart
    Z Club Member
    Official Trader

    Well.....that could have been better.......:hurray:
     
  4. Wyn

    Wyn
    Z Club Member

    Well done m8 :thumbs:

    Give it a few mths n you'll be looking for more lol :D

    (btw you want to vent that breather into a catch tank. else you'll end up with oil everywhere after a while)
     
  5. franky

    franky
    Z Club Member

    Which way round does the paint code sticker go?
     
  6. SeanDezart

    SeanDezart
    Z Club Member
    Official Trader

    As one opens the bonnet it stares at you - Neil's is the correct way around.
     
  7. Fairlineguy

    Fairlineguy
    Z Club Member

    Don't know about that? Rich did say that bigger injectors and turbo would get me
    450hp ish with stock engine internals.
    At least with the new ecu set up the foundations are there for future work.
    I do have a bulkhead catch tank for the breather just not fitted in the photo

    Just got to complete the small job list on the white board in the garage then
    Out on the road
     
  8. Wyn

    Wyn
    Z Club Member

    What did I say lol

    The seed is sown :D
     
  9. Fairlineguy

    Fairlineguy
    Z Club Member

    Ahh
    Not sure that old dodgy sump of yours will be up to it. Lol
    Joking aside its doing its job and saved me loads of hassle
     
  10. Dave B

    Dave B
    Z Club Member

    Standard turbo and injectors? Seems a very good result
    Wonder if the aftermarket inlet manifold helps there. I had a link g4 on my R32 gtr, supposed to be one of the best Ecu’s out there


    Sent from my iPhone using Tapatalk
     
  11. franky

    franky
    Z Club Member

    I can't picture it, genuine question as you could see the point either way. The sticker would have been put on in advance of the bonnet at the factory so I can picture it the other way.

    I can't find the pic of my car with the original sticker on.
     
  12. SeanDezart

    SeanDezart
    Z Club Member
    Official Trader

Share This Page