Seatbelt repositioning - 240z

Makesy

Makesy

Club Member
Hi all

My car only came with some less than ideal lap belts fitted so I'm installing new aftermarket inertia reel belts.

I fitted them in a roundabout way in the stock positions however I find the angle very high and cuts into my neck (i'd read about this issue some time ago).

Has anyone done this and if so how did you go about it?

My initial thoughts are to put a plate with a captive nut spanning the gap next to the shock tower (will grab a pic later to better explain) but open to better ideas.

All help welcome. Thanks in advance
 
Makesy

Makesy

Club Member
Pic below shows the area I referred to.

My initial thoughts are to span a piece of steel with a captive nut over the area marked in red, leaving enough of a gap for the plastic trim to fit.

Has anyone done this? (Or anything better? :))

1681420813773.png
 
Last edited:
You must log in or register to reply here.
Top