Replacement air ducts | The Z Club of Great Britain
  1. The Z Club relies on the support of it's paid members - join the club or renew your membership here.

Replacement air ducts

Discussion in 'Exhaust & Cooling Systems' started by Wrighty, Nov 24, 2021.

  1. Wrighty

    Z Club Member

    Is anyone remanufacturing these or know of any old stock. Both of mine are holed and brittle.[​IMG] E70F2DDB-9504-4E16-AD92-2486F62892B0.jpeg
  2. SeanDezart

    SeanDezart Well-Known Forum User

  3. moggy240

    moggy240 INSURANCE VALUATIONS OFFICER Staff Member Moderator

    Was someone on here on about 3d printing some
  4. atomman

    Z Club Member

    I 3d printed some for my 240 , I put a link on a thread to the file but cant seem to find it right now


    IMG_20210702_101337_3 (1).jpg
    moggy240 and Minksport like this.
  5. Russell

    Z Club Member

    What did you print them in and how have they held up?

    I need to design some new ones for mine as the holes they mount into will be occupied by intercooler pipes
  6. atomman

    Z Club Member

    They have held up petty good to be honest, I printed them on an Ender 3. could get them to look a bit better if i ran a hot air gun over them a bit or change the resolution.

    maybe you could stretch them a bit in CAD and use the bottom holes in the front panel instead ?
  7. Russell

    Z Club Member

    Exactly my thought, although I have the wiring loom going through the bottom one on the driver side
    atomman likes this.
  8. jonbills

    ZClub Administrator

  9. Wrighty

    Z Club Member

Share This Page